Dentemp Custom Loose Cap And Lost Filling Repair, 1 Box Each, By Emerson Healthcare Emerson Healthcare Factory Shop

Directions: Read directions carefully before using. To Replace a Lost filling: Wash hands thoroughly. Rinse out cavity with warm water. Do not dry; leave moist. Use the applicator to remove a small amount of material from the vial, form into a ball with your fingers, and press firmly into the cavity. Bite down several times to insure proper bite. Remove any excess material. Rinse out mouth well with water. Allow 1 hour to set before eating. To Re-cement Loose Caps or Crowns: Wash hands. Prepare crown by carefully removing as much old cement as possible from the inside of the crown. Rinse well. Clean and rinse the tooth area with water and leave moist. Fit the crown back on the tooth before applying Dentemp O.S. Make sure it fits properly. If you cannot do this, do not proceed. See your dentist. Use the applicator to remove a small amount of material from vial. Place a thin layer of material (the thickness of 2-3 sheets of paper) on the upper inside wall of the crown. Place crown on wet tooth and press firmly. Bite down several times to ensure proper fit. If the bite is not completely comfortable, remove and repeat all steps until the crown feels normal. Remove any excess material. Rinse out mouth well with water. Allow at least 1 hour to set before eating. Note: When replacing a bridge apply Dentemp O.S. sparingly to only 1 hollow tooth at each end of the bridge. Dentemp O.S. should not be used on implants or posts without the dentist’s advice. Store at room temperature with container closed to keep material soft.